Ide: Assuming 33MHz system bus speed for PIO modes override with idebus=xxĪLI15X3: IDE controller at PCI slot 00:10.0ĪLI15X3: not 100% native mode: will probe irqs later Cpuinfo 4620 driver#Uniform Multi-Platform E-IDE driver Revision: 7.00beta4-2.4 RAMDISK driver initialized: 16 RAM disks of 8192K size 1024 blocksize PCI: PCI BIOS revision 2.10 entry at 0xfd8e9, last bus=2īased upon Swansea University Computer Society NET3.039 Mtrr: v1.40 (20010327) Richard Gooch detected mtrr type: AMD K6 Mount cache hash table entries: 512 (order: 0, 4096 bytes)īuffer cache hash table entries: 8192 (order: 3, 32768 bytes) Inode cache hash table entries: 8192 (order: 4, 65536 bytes) Kernel command line: ro root=LABEL=/ rhgbĬalibrating delay loop. That's how you get modern NetBSD packages for stuff like Cobalt RaQs (150-250 MHz MIPS CPU) or old sun4m systems, without it taking ages. NetBSD's cross compile system makes it even easier, if you want to go the NetBSD route - you can build from any architecture, to any architecture. You just have to set GCC flags to make sure you're not auto-picking the CPU optimizations based on the host system. Cpuinfo 4620 install#For embedded stuff I just build from a 32-bit Slackware install on a VM, on my modern 64-bit workstation. With 768 MB RAM installed you should have no problem with just installing a modern 32-bit distro.įYI, what you compile a kernel on has no bearing on the target's hardware, especially if they're both the same basic CPU architecture. I ran a bunch of different stuff on them when I was using them as my main systems - Red Hat, Mandrake, SuSE, Slackware, Vector Linux (Slackware based), even Knoppix Live CDs. Current Slackware and OpenBSD both run fine. Sure, ran them back when they were current, and still have a few machines running them.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |